The 1 st LED lights to indicate that the pairing mode has been entered.Ģ. Press and hold the Pairing/Test button until the AM20 makes a beep sound, then release the Pairing/Test button. Use the slider control to adjust the volume of the doorbell ring, phone ring or to turn power off.Ī. How do you control the volume on the unit?Ī. Hang the base onto the two screws (supplied) and pull the base down to lock it on. Drill two holes horizontally, 96mm apart, and leave the screws protruding 5mm from the wall.Ģ. Remove the protective paper from the adhesive tape on the back of the doorbell and stick to the required door or window.Ī. The doorbell can be stuck onto a door or window using the supplied strong adhesive tape. Stick the white name plate over the two holes. Hang the doorbell onto the two anchors and then insert and tighten the screws. Drill two holes horizontally, 15mm apart and place the supplied anchors into the two holes. The doorbell can be fixed on a wall or a door frame. What are the steps to setting up the doorbell?Ī. Plug the AC adaptor into the mains power point. 1) Insert 4 AA Alkaline batteries (not supplied) into the battery compartmentĢ) Connect one end of the telephone line cord to the AM20 and the other end to the wall socket.ģ) Connect the telephone cable between the AM20 and your telephone.Ĥ) Plug the power cable into the power AC adaptor jack of the AM20. Damage to this product or the phone system may occur.Ī. Do not connect this product to an extension of a Digital Telephone system (PBX).This product has been designed for individuals who are hard of hearing and has volume which is louder than a standard product.Do not use this product during a thunderstorm as it is possible to get a shock.It is very important that you read the User Guide carefully as it contains detailed information on setup and operational issues which you will need to be aware of to ensure this product operates properly.įollowing is a list of some of the important issues and important warnings which you need to be aware of: Do not install the product in areas where there is the risk of an explosion, or exposure to smoke, dust, vibrations, chemicals, moisture and heat.
0 Comments
Leave a Reply. |